国产三级伦理在线,久久久久黄久久免费漫画,成人国产精品日本在线,欧美美最猛性xxxxxx

成都鑫業達自動化成套設備有限公司正品  現貨供應    歡迎來電咨詢   
聯系人：楊小姐    電話：15882174796     座機：028-84472033  QQ：2049063673

B9

A10

B10

15

XW2C-20G6-IO16

Wiring Diagram

Connect the short bar according to the application as shown in the following table.

Connecting to PLC I/O Unit

 Connecting to Field Network Equipment

Application Connection Method

NPN inputs (+ common) Connect terminal A9/B9 and the positive power terminal. Terminal A10/B10 do not need to be connected.

PNP inputs (? common) Connect terminal A9/B9 and the negative power terminal. Terminal A10/B10 do not need to be connected.

Outputs Connect terminal A9/B9 and the negative power terminal. Terminal A10/B10 and the positive power terminal

do not need to be connected.

Application Connection Method

NPN inputs

PNP inputs

Outputs

Connect terminal A9/B9 and the negative power terminal.

Connect terminal A10/B10 and the positive power terminal.

Wiring

 Always turn OFF the power supply before wiring.

Otherwise, cables or other conductors can short the

terminals and cause the Unit to fail.

Do not connect or disconnect Connectors with the power

turned ON. Otherwise, it may cause malfunctions.

 Wiring Terminal Blocks

Using Crimp Terminals

(With a Terminal Block with M3 Screws)

 Terminal Screw Tightening Torque

Use a tightening torque of 0.7 N·m when connecting wires or

crimp terminals to the terminal block.

 Mounting Units to and Removing Units from DIN Track

 XW2C Connector-Terminal Block Conversion Units can be

mounted side-to-side on DIN Track.

 Secure both ends of the XW2C with End Plates.

When removing the Unit from a DIN Track, insert a flat-head

screwdriver into the slider and pull the lock out.

Handling M3 Screw and Round Terminals

Raise the M3 screw with a Phillips screwdriver as shown in

diagram (1) and slide the screw toward you to keep the space

成都鑫業達自動化成套設備有限公司正品  現貨供應    歡迎來電咨詢   
聯系人：楊小姐    電話：15882174796     座機：028-84472033  QQ：2049063673