商鋪名稱:河北會泉泵業有限公司
聯系人:徐經理(先生)
聯系手機:
固定電話:
企業郵箱:1815991877@qq.com
聯系地址:河北省石家莊市橋西
郵編:5000
聯系我時,請說是在焊材網上看到的,謝謝!
廂式污泥壓濾機給料泵@章貢125ZJW-II廂式污泥壓濾機給料泵怎么樣
3、 軸: 短跨距和軸徑加粗設計,剛性好,運行平穩可靠; 軸采用全密封設計,不接觸液體,不腐蝕螺紋,維修方便; 轉子短時反轉無損害,且換向方便;
一、產品概述
ZJW型壓濾機專用泵本由公司結合各壓濾機生產廠家及使用現場的實際工況,精心設計開發的新一代無泄漏壓濾機專用泵,該產品廣泛應用于壓濾機入料泵應用尤為廣泛,通過在冶金、礦山、電廠、化工等行業中的使用,發現該系列產品具有結構合理,運行可靠,壽命長等特點。該系列產品采用獨特的水力設計及雙級葉輪的結構,確保了其性能曲線比一般YLB、UHB、HFTK等普通離心泵改造而成的壓濾機入料泵更陡,更適合壓濾機入料的特殊使用工況。jdhuiquan520
廂式污泥壓濾機給料泵@章貢125ZJW-II廂式污泥壓濾機給料泵怎么樣
左邊的半個月牙形的容積由大變小,構成了壓縮過程(相當于排氣室)。被抽氣體由進氣管8和進氣口4進入吸氣室。轉子進一步轉動,使氣體受壓縮,經過排氣口6和排氣管7排出。排出的氣體和水滴由排氣管道7進入水箱10,此時氣體由水中分離出來,氣體經管管道9排到大氣中,水由水箱進入泵中,或經過管道11排到排水設備中。
二、創新技術特點
1. Unique sealing device using negative pressure technology plus combined sealing device, in the increasing pressure and flow is gradually reduced, sealing components do not bear pressure, especially in the late press period due to the pump under large pressure, its innovative seal structure design, to ensure that the shaft seal basically achieved no leakage.
2. Structural design of two-stage impeller
The pump adopts the double main pump body, the structure design of the double main impeller, completely solves the requirement that the single pump leaf wheel pump has too much vibration and noise, flat performance curve, narrow leaf rotation path, poor performance and so on, and the change of resistance when the filter press feed is very suitable for the requirements of high flow and low pressure feeding and small flow rate.
3. Double impeller pump than single leaf wheel pump anti-wear resistance is better
Because the double impeller pump at the lower impeller outlet line speed to obtain higher pump outlet pressure to overcome the single-leaf wheel pump in order to increase the pressure and increase the impeller line speed, resulting in impeller, pump shell wear increased shortcomings, effectively improve the life of water pump and other overcurrent components.
4. Wide range of applications
The product can be made of cast steel, high chromium cast iron (corrosion-resistant wear-resistant materials), stainless steel and other materials, can be adapted to different media needs, the user selection of a wider range.
5. Adjustable gap between impeller and pump wall
Unique bearing box design, users in the regular time after use, due to wear caused by pressure drop, can be adjusted impeller and pump wall gap to continue to ensure the high pressure of the pump, improve the service life of the pump, extend the overhaul cycle, overcome the traditional single-leaf wheel pressure filter pump due to the wear pressure drop fast, often replace the impeller service life is short
廂式污泥壓濾機給料泵@章貢125ZJW-II廂式污泥壓濾機給料泵怎么樣
單級水環泵的極限壓力可達8~2×103Pa,雙級水環泵的極限壓力可達1×102Pa,排氣量為0.25~500m3/h。
三、性能參數表
型號 |
轉 速 (r/min) |
流 量 (m3/h) |
揚 程 (m) |
最大軸功率 (k/h) |
選配電機 功率(kw) |
65ZJW-III |
1480 |
27.5 41.4 55.2 69.0 80.0 |
76.0 72.2 66.1 56.0 43.5 |
22.3 |
Y225S-4 30KW |
Y225S-4 37KW |
|||||
80ZJW-III |
1480 |
40.0 60.0 80.0 100 115 |
76.0 72.2 66.1 56.0 43.5 |
32 |
Y225S-4 37KW |
Y225M-4 45KW |
|||||
100ZJW-III |
1480 |
56.0 85.0 113 150 169 |
73.3 69.0 62.5 51.2 44.0 |
49 |
Y225M-4 45KW |
Y250M-4 55KW |
|||||
125ZJW-III |
1480 |
70.0 105 140 186 245 |
73.5 71.6 68.6 61.9 48.5 |
62.5 |
Y250M-4 55KW |
Y280S-4 75KW |
|||||
125ZJW-III |
1480 |
79.7 119 159 211 279 |
80.0 78.0 74.8 67.5 52.9 |
78.2 |
Y280S-4 75KW |
Y280M-4 90KW |
|||||
125ZJW-III |
1480 |
58.0 87.0 116 154 203 |
91.8 89.1 85.7 77.3 60.6 |
64.7 |
Y280S-4 75KW |
Y280M-4 90KW |
并承攬帶圖加工事務。產品廣泛用于工程配套,NWLNLYWNSL型地坑泵等產品。現在產品深受用戶好評。“質量牢靠,用戶是天主,誠信守約”是企業的主旨。用戶的滿足是咱們的終政策。河北會泉泵業有限公司的誠信。IH系列化工泵。ZQ型潛渣泵,PW,PW(L),WD(G)型污水泵,WQ系列潛污泵,PN,PNJ,PNL型泥漿泵,ISISWISGBA型清水泵,QJ型潛水泵,DDGGC型高壓鍋爐泵。電力,煤炭,石油化工,環境保護工程,建材,火電煙氣脫硫,污水處理,城市工廠給排水等許多范疇。公司的泵型首要有:ZJ(L)AHHHAHRSPR型渣漿泵,DT,TL。礦山河北會泉泵業有限公司產品廣泛應用于冶金TLL系列脫硫泵HW混流泵實力和產質量量取得業界的認可。